|
XLS Series
These
four models of the series are the XLS-202, XLS-402, XLS-602,
and XLS-802. They are identical except for output power and weight.
The XLS Series of power amplifiers
from Crown represents a new era in affordable, quality power
amplification. Rugged 2U chassis, incorporating the best of tried-and-true
design principles and innovative features.
XLS Series amplifiers are professional
stereo power amplifiers engineered to meet demanding audio requirementsreliably
and within budget. Plus, every XLS Series amplifier is backed
by Crowns unequaled Three-Year, No-Fault, Fully-Transferable
Warranty that covers everything. With over five decades of experience
designing and building rock-solid products, Crown is the standard
in amp technology. So check out the affordable, Crown XLS Series.
They are a powerful argument for quality and value!
Features
Reliable design incorporates many popular features
Housed in a rugged, all-steel 2U chassis
Efficient forced-air fans prevent excessive thermal buildup
Electronically balanced XLR inputs; touchproof binding post and
Speakon® outputs
Precision detented level controls, power switch, power LED, and
six LEDs which indicate signal, clip and fault for each channel.
Three-Year, No-Fault, Fully Transferable Warranty completely
protects your investment and guarantees its specifications
The following applies to units
in Stereo mode with 8-ohm loads unless otherwise specified.
Performance
Sensitivity (volts RMS) for full rated power at 4 ohms: 1.25
V.
Frequency Response (at 1 watt)
22 Hz to 20 kHz: +0 dB, –0.8 dB.
Signal-to-Noise Ratio (20 Hz
to 20 kHz)
A-weighted, below rated power:
>98 dB.
No weighting, below rated power:
>93 dB.
Total Harmonic Distortion (THD):
<0.5%.
Intermodulation Distortion (IMD):
(60 Hz and 7 kHz at 4:1) from full rated output to –40 dB:
< 0.3%.
Damping Factor (8 ohm) 10 Hz
to 400 Hz: >200.
Crosstalk (below rated power)
at 1 kHz: –76 dB. at 20 kHz: –58 dB.
Input Impedance (nominal): 20
kilohms balanced, 10 kilohms unbalanced.
Load Impedance: Rated for 2 to
8 ohms per channel in Stereo, 4 to 8 ohms in Bridge Mono.
AC Line Voltage and Frequency
Configurations Available (±10%): 120 VAC 60 Hz, 100 VAC
50/60 Hz, 220 VAC 50 Hz, and 230-240 VAC
Controls
Level: Two front-panel rotary level controls, one for each channel.
Power: Front-panel switch; on
when in the IN position.
Circuit Breaker: Back-panel breaker
provides overload protection.
Mode Switch: Back-panel switch
selects Dual or Bridge-Mono mode.
Indicators
Signal Presence Indicators: Two green LEDs, one for each channel,
illuminate when the channel’s input signal exceeds –40
dBu.
Clip Indicators: Two red LEDs,
one for each channel, illuminate when the channel’s output
is being overdriven.
Power Indicator: Blue LED indicates
amplifier has been turned on and AC power is available.
Fault Indicator: Two red LEDs
illuminate when amplifier is in protect mode. Also illuminates
briefly during normal power-up when amplifier is first switched
on. |